1. Make sure your TV and receiver are turned on.
2. Press POWER to turn on the controller. Wait for the lights to stop ashing
and for the COAX CONNECTION light to remain on.
3. Press SCAN.
• The antenna will scan for the selected satellites. The four SCAN
PROGRESS lights will cycle on and off to indicate a scan is in progress.
• As satellites are located, the corresponding SCAN PROGRESS lights will
turn on (see below).
• When scan is complete, the appropriate lights will be on to show which
satellites were found.
• Wait for the program guide to download and then select your desired
channel. Enjoy!
OPERATION
DISH CUSTOMERS USING TAILGATER MODE:
If you have a DISH model ViP211z, ViP211k, ViP211 or 411 single tuner HD
receiver, you can use the DISH Tailgater user interface on your receiver.
Choose Tailgater Mode in section 3, and after turning on your TV, receiver and
controller, follow the on-screen instructions.
5
To Next Page
Loading...
