What to do if KING UC1000 antenna unit scans but does not find satellite?
If your KING Controller's antenna unit scans but fails to locate a satellite, it might be due to an obstruction in the line of sight. To resolve this, move the antenna unit to a location with a clear view of the southern sky. Then, turn the controller off and back on to initiate a new scan.
Why my KING UC1000 Controller will not turn on?
If your KING Controller fails to power on, there are a couple of potential reasons. First, ensure that the power supply is correctly plugged into both a functioning power outlet and the controller itself. Also, when pressing the power button, press and immediately release it; avoid holding the button down.
Why KING UC1000 Controller antenna doesn’t find right satellites?
If the antenna of your KING Controller isn’t finding the correct satellites, it's possible that the controller is programmed for the wrong service. To fix this, enter configuration mode and verify that the flashing SCAN PROGRESS lights align with the lights specified in the service chart.
What to do if pressing and holding buttons does not enter indicated mode on KING UC1000 Controller?
If pressing and holding buttons on your KING Controller doesn't activate the indicated mode, you might not be holding the buttons long enough. Make sure to press and hold the buttons until the indicated lights begin to flash, which can take up to 15 seconds.
Instructions for DISH customers using the simplified KING Tailgater user interface.
Lists the five main sections required to start watching TV.
Diagram and instructions for connecting the UC1000 Controller to antenna and receiver.
Critical warning against using the UC1000 with a power injector.
Step-by-step guide to enable or disable the controller's alarm feature.
Explains when the alarm sounds and how to turn it off.
Instructions for configuring the antenna for different satellite services like DISH, DIRECTV, Bell TV.
A chart mapping service options to satellites and scan progress lights.
Specific settings for DIRECTV SD and SD with Locals receivers.
Details for DISH and Bell TV receivers, including Tailgater Mode and software configuration.
Specific steps for Wally receivers, including diagnostics and satellite verification.
Specific steps for VIP receivers, focusing on the check switch test.
Visual examples of correct installation summary screens for DISH configurations.
Visual examples of correct installation summary screens for Bell TV configurations.
Instructions for DISH customers using Tailgater mode, focusing on scanning and channel selection.
Chart showing scan progress lights for identified satellites by service option.
Steps to resolve issues with the controller not turning on or responding.
Troubleshooting for incorrect button press duration or mode entry.
Solutions for antenna scanning issues or finding incorrect satellites.
Details of the one-year parts limited warranty for the UC1000 Controller.
General| Operating Voltage | 24 VDC |
|---|---|
| Digital I/O Pins | 16 |
| Analog Input Pins | 8 |
| Type | Programmable Logic Controller |
| Interface | Ethernet |
| Communication Interfaces | Ethernet |
To Next Page
