1. Press POWER to turn on the controller. Wait for the lights to stop ashing
and for the COAX CONNECTION light to remain on.
2. Simultaneously press and hold POWER and SCAN for ve seconds.
Controller begins beeping.
• Single Beep (beep...beep...beep) Alarm is OFF.
• Double Beep (beep beep...beep beep) Alarm is ON.
3. Press and release SCAN to toggle between the on and off conditions.
Beep pattern will change to indicate new condition.
4. When alarm is in desired condition, press and hold SCAN for 5 seconds to
save in memory.
COAX CONNECTION light will turn solid and SCAN PROGRESS lights will
stay off.
5. Press POWER to turn off the controller. Go to section 3.
This unit is shipped from the factory with the alarm feature in the ON
condition. If you wish to have the alarm in the ON condition, you can skip
this section and go to section 3. To disable the alarm, follow the instructions
below.
ALARM OPERATION
If the coax cable is disconnected from the antenna unit or the controller while
the system is turned on or in standby mode, the controller will sound an
audible alarm.
To turn off the alarm when it is sounding, press POWER until the controller
turns off.
You can change the alarm condition at anytime by following the steps above.
ALARM CONFIGURATION
2
To Next Page
Loading...
