KING UC1000 - Alarm Operation; Alarm Trigger and Silencing

1. Press POWER to turn on the controller. Wait for the lights to stop ashing
and for the COAX CONNECTION light to remain on.
2. Press and hold SCAN for ve seconds. The COAX CONNECTION light and
the SCAN PROGRESS lights that indicate the currently selected service will
begin ashing.
3. Press SCAN repeatedly to scroll thru the available service options.
4. When the correct lights turn on to show your desired satellite conguration,
press and hold SCAN for ve seconds to save in memory.
All SCAN PROGRESS lights will turn off and the COAX CONNECTION light
will stop ashing and remain on.
5. Press POWER to turn off the controller. Go to section 4.
The KING UC1000 Controller is factory preset for DISH HD and SD (satellites
110, 119 and 129).
If this is your desired service option, you do not need to congure your
antenna. Go to section 4.
If you wish to use a different DISH service option, or if you have DIRECTV or
Bell TV service, you will need to recongure the antenna as shown below.
ANTENNA CONFIGURATION
3