Kingfisher CLBH60ASBL

Questions and Answers

C
Christy BrooksAug 9, 2025
Why is the suction performance reduced on my Kingfisher CLBH60ASBL Ventilation Hood?
- M
  Marilyn ArnoldAug 10, 2025
  Reduced suction performance in your Kingfisher Ventilation Hood can occur if the speed setting is too low; try selecting a higher speed. Also, check if the aluminum filters are dirty and clean them. Ensure that the top vent is free from obstructions. Verify the optional vent kit is correctly installed according to the manufacturer's instructions. Finally, the vent hose should be the correct diameter without reductions or restrictions.
A
aaron96Aug 15, 2025
What to do if both the light and motor do not work on my Kingfisher Ventilation Hood?
- J
  Judy WellsAug 15, 2025
  If both the light and motor of your Kingfisher Ventilation Hood aren't working, first check the power supply to ensure it's properly connected. If the power connection is fine, the light bulb may have blown and you need to contact customer helpline to arrange an engineer visit.
G
Gary JohnsonAug 20, 2025
Why is my Kingfisher CLBH60ASBL vibrating excessively?
- G
  George IbarraAug 20, 2025
  Excessive vibration in your Kingfisher Ventilation Hood may be due to improper installation on the brackets; take down the appliance and check it is properly fixed. Another cause could be a damaged fan blade, in which case you should switch off the appliance, and repair should be carried out by qualified service personnel only. Also, the fan motor might not be fixed tightly.
B
Brian ShepardAug 25, 2025
Why do cooking smells linger when my Kingfisher Ventilation Hood is working normally?
- M
  Matthew RobinsonAug 25, 2025
  If cooking smells linger even when your Kingfisher Ventilation Hood is running, it might be because a carbon filter is not fitted when in recirculation mode, or the existing carbon filter is full of grease. Fit a carbon filter or replace the carbon filter.
B
Bradley EwingAug 29, 2025
What does it mean when my Kingfisher Ventilation Hood display shows "ES"?
- A
  alyssa43Aug 29, 2025
  If your Kingfisher Ventilation Hood display shows "ES", this indicates a sensor error. Turn off the power supply at the consumer unit, wait two minutes, and then turn the power back on. Run the calibration procedure again. If the error persists, contact the customer helpline. Note that the hood will still operate in manual mode.
A
Angel ReedSep 4, 2025
What does it mean when my Kingfisher CLBH60ASBL display shows "EC"?
- A
  Amanda MasonSep 4, 2025
  If your Kingfisher Ventilation Hood display shows "EC", this indicates a calibration error. Run the calibration procedure again. If the error continues, contact the customer helpline. Note: The hood will still operate in manual mode.

Kingfisher CLBH60ASBL Specifications

General

Brand	Kingfisher
Model	CLBH60ASBL
Width	60 cm
Color	Black
Material	Stainless Steel
Number of Speed Settings	3
Noise Level	65 dB
Voltage	220-240 V
Frequency	50 Hz
Lighting	LED
Filter Type	Aluminum