Kingfisher CLCH60LKSS

Questions and Answers

J
Jenna MedinaAug 11, 2025
Why is the suction performance reduced on my Kingfisher CLCH60LKSS Ventilation Hood?
- W
  William SampsonAug 11, 2025
  Reduced suction performance on your Kingfisher Ventilation Hood may occur if the speed setting is too low; try selecting a higher speed. The aluminum filters may be dirty and need cleaning. Check if the top vent is obstructed and clear any obstructions. If you're using an optional vent kit, ensure it's correctly fitted according to the manufacturer’s instructions. Also, the vent hose should be the correct diameter throughout with no reductions or restrictions, as per the installation instructions.
A
Alexis MendozaAug 20, 2025
What to do if my Kingfisher CLCH60LKSS Ventilation Hood is vibrating excessively?
- J
  johnsondouglasAug 20, 2025
  Excessive vibration in your Kingfisher Ventilation Hood could be due to improper installation on the brackets; take down the appliance and check it is properly fixed. Another cause could be a damaged fan blade, in which case you should switch off the appliance, and repair should be carried out by qualified service personnel only. Also, the fan motor may not be fixed tightly.
S
sandralewisAug 30, 2025
What to do if my Kingfisher CLCH60LKSS Ventilation Hood works normally but cooking smells linger?
- R
  ramseyemilyAug 31, 2025
  If your Kingfisher Ventilation Hood works normally, but cooking smells linger, it might be because the carbon filter is not fitted in recirculation mode or is full of grease. Fit a carbon filter or replace the carbon filter.