> Only use the product in daylight or good artificial light.
> Keep your body upright during operation. Do not lean
forward. Make regular breaks and change your working
position to stay concentrated.
> Keep firm footing and balance during operation. Always
use the harness, if provided.
> Stop the engine before
• cleaning or when clearing a blockage,
• checking, carrying out maintenance or working on the
product,
• adjusting the working position of the cutting attachment,
• leaving the product unattended.
> Ensure that the product is correctly located in a designated
working position before starting the engine.
> While operating the product, always ensure that the
operating position is safe and secure.
> Do not operate the product with a damaged or worn
cutting attachment.
> Keep the engine and silencer free of debris, leaves and
excessive lubricant to reduce fire hazards.
> Always ensure that all handles and guards are fitted when
using the product. Never attempt to use an incomplete
product or one fitted with an unauthorised modification.
> Always use two hands to operate a product fitted with two
handles.
> Always be aware of your surroundings and stay alert for
possible hazards of which you may not be aware due to the
noise of the product.
> Be careful when handling any cutting attachment / sharp
edge fitted for trimming the filament line length. Ensure a
new filament trimming line is installed correctly before
turning the product on.
> Always ensure that air vents are kept clear of debris.
> Only use cutting attachments as listed in the technical data
within these instructions. The use of other attachments
leads to hazards resulting in personal injuries and damage
to property.
13
Getting started...
FPGTP25-2
Safety information
EN
To Next Page
Loading...
