Kingfisher FPGTP25-2 - Recycling and Disposal

In more detail...
Troubleshooting
46
FPGTP25-2
Troubleshooting
WARNING! Only perform the steps described within
these instructions! All further inspection,
maintenance and repair work must be performed by
an authorised service centre or a similarly qualified
specialist if you cannot solve the problem yourself!
Problem
Possible cause
Solution
Engine does not
start
Not enough fuel in fuel
tank
Add fuel
Primer has been not
pressed at cold start
Press the primer and
restart
Primer has been pressed
at warm start
Dry spark plug
Spark plug is wet
Dry spark plug
Spark plug is damaged
Replace spark plug
Spark plug connector lose
Attach properly
Engine stops
Not enough fuel in fuel
tank
Add fuel
Cutting attachment is
blocked
Remove blockage
Unsatisfactory
result
Cutting attachment blunt
Sharpen or replace the
cutting attachment
Excessive
vibration/noise
or exhaust
Cutting attachment is
dull/damaged
Replace with a new
one
Bolts/nuts are loosen
Tighten bolts/nuts
Petrol/oil is incorrect
Empty out unused
petrol/oil and refill with
the correct petrol/oil
EN