17
NMRS1500
Getting Started . . .
NOTE: A full grass catcher will reduce the performance of this product.
4.
remove it.
5.
Empty the collected material onto a compost heap and reattach the grass catcher
(15) onto the product.
WARNING! The motor must be switched off and the cutting device must have
Connection to the power supply (for UK only)
WARNING! Always use a residual current supply (RCD) protected supply.
designed for outdoor use and not lighter than H05VV-F or H05RN-F,
2x1.0 mm² and max 75 m.
1. Make sure the lock-off button (19) is in its off position..
2. Connect the power plug to a suitable power source.
3. Now your product is ready for use.
Connection to the power supply (not for UK)
For safety reasons the product is equipped with a short power cord (4). Do not connect
the product directly to the power supply using this power cord. A proper extension cord
is required for operation. Observe the technical requirements for this product when
purchasing an extension cord.
WARNING! For your safety, it is required that the product is always supplied
be supplied via a residual current device (RCD) with a tripping current of
not more than 30mA
4. Make sure the lock-off button (19) is in its off position.
5. Double the extension cord about 30 cm (12 inches) from the end. Lead the loop
through the hole and hook the loop over the cord strain relief (17). Gently pull on
Do not attempt to use the product without the grass catcher
5
Empty the grass catcher (15) frequently during use. Do not wait until it is completely
Before you start
3663602627173_MNL_GB_V03.indd 17 30/3/2023 11:50 AM
To Next Page
Loading...