28
NMRS1500
In more detail . . .
Transportation
1.
Switch the product off and disconnect it from power supply before transporting it
anywhere.
2. Attach transportation guards, if applicable.
3.
Adjust the cutting depth to the transportation stage (refer to “Product functions –
Cutting depth adjustment”).
4. Always transport the product by its handle.
5.
Protect the product from any heavy impact or strong vibrations which may occur
during transportation in vehicles.
6. Secure the product to prevent it from slipping or falling over.
Troubleshooting
Therefore check the product using this section. In most cases the problem can be
solved quickly.
WARNING!
further inspection, maintenance and repair work must be performed by an
Problem Possible cause Solution
1. Product does
not start
1.1. Not connected to power
supply
1.1. Connect to power supply
1.2. Power cord or plug is
defective
1.2. Check by a specialist
electrician
1.3. Other electrical defect to
the product
1.3. Check by a specialist
electrician
1.4. Lock-off button not
pressed
1.4. Press lock-off button
lever
Care and maintenance / Troubleshooting
3663602627173_MNL_GB_V03.indd 28 30/3/2023 11:50 AM
To Next Page
Loading...