23
NMRS1500
In more detail . . .
General operation
1.
Check the product, its power cord and plug as well as accessories for damage
before each use. Do not use the product if it is damaged or shows wear.
2.
3.
Push the product forward by its handle. Keep the handle dry to ensure safe support.
4.
Ensure that the air vents are always unobstructed and clear. Clean them if necessary
with a soft brush. Blocked air vents may lead to overheating and damage the product.
5.
Switch the product off immediately if you are disturbed while working by other
people entering the working area. Always let the product come to complete stop
before putting it down.
6. Do not overwork yourself. Take regular breaks to ensure you can concentrate on
the work and have full control over the product.
WARNING!
and on what special days products are allowed to be used and what
the regulations in order to preserve a peaceful neighbourhood and avoid
7. Mow the lawn before working and fertilise afterwards.
8. Make sure that the lawn is clear of stones, sticks, wire or other objects that could
damage the product or its motor.
9. Select the suitable cutting depth for the actual grass height.
10.
Do not work with this product on a wet lawn because it tends to stick to the
underbody of the product, preventing the proper discharge of collected material,
and it could also cause you to slip and fall.
11. Slowly push the product forward. Move the product at an appropriate speed. Do
not move it too fast as this will prevent the discharge opening from getting blocked
and the motor from becoming overloaded.
12.
Work in slight overlapping rows. The most effective pattern for scarifying lawns
is straight lines along one of the sides. This will keep the rows even and ensures
Fig. 27
Operation
3663602627173_MNL_GB_V03.indd 23 30/3/2023 11:50 AM
To Next Page
Loading...