Kingfisher NMRS1500 - Care and Maintenance

25
NMRS1500
In more detail . . .
The golden rules for care
WARNING! Always switch the product off, disconnect it from power supply
and let the product cool down before performing inspection, maintenance
1. Keep the product clean. Remove debris from it after each use and before storage.
2. Regular and proper cleaning will help ensure safe use and prolong the life of the
product.
3. Inspect the product before each use for worn and damaged parts. Do not operate
WARNING! Only perform repairs and maintenance work according to these
General cleaning
1. Clean the product with a dry cloth. Use a brush for areas that are hard to reach.
2. In particular clean the air vents (9) after every use with a cloth and brush.
3. Remove stubborn dirt with high pressure air (max. 3 bar).
NOTE: Do not use chemical, alkaline, abrasive or other aggressive detergents
or disinfectants to clean this product as they might be harmful to its surfaces.
4. Check for worn or damaged parts. Replace worn parts as necessary or contact an
authorised service centre for repair before using the product again.
Underbody and cutting device
WARNING! Wear safety gloves when working on the cutting device and
1. Keep the underbody and cutting device (21) clean and free of debris.
2. All screws, nuts and bolts must be checked periodically for tightness before
operation. After prolonged use, especially in sandy soil conditions, the cutting
will be reduced and the cutting device should be replaced.
Care and maintenance
3663602627173_MNL_GB_V03.indd 25 30/3/2023 11:50 AM