Version 3.1 _March 2017 Page | 7
4. Installation of the Unit
Improper levelling may result in cabinet deformation and reduced cooling
performance.
4.1 Choosing the Installation Spot -
The KLC Models are intended for indoor use only.
Performance of these Models is highly influenced by the environmental conditions
in which they are in use. To maximise the performance of the KLC Models the
following is recommended:
The unit is not to be placed near any kind of heat source.
The unit is not to be placed near or inside air streams produced by
ventilation fans, open doors and/or windows.
The unit is not to be situated under a roof mounted ventilation system.
The units should have sufficient space to “breathe”. Always keep at least a
75mm gap around the back, top and sides of the cabinet. (Always use the
rear spacer to ensure minimum clearance).
The unit is not to be placed under direct sunlight.
Keep clear of obstruction all ventilation openings in the appliance enclosure
or in the structure for building-in.
In order to reduce flammability hazards the installation of this appliance
must be carried out by a suitably qualified person.
To Next Page
Loading...