Version 3.1 _March 2017 Page | 8
The appliance should be located on smooth flat surface during operation.
Check rollers / castors / adjustable feet below the appliance against damages
to ensure stability. Take necessary precautions if tilting is needed during
installation.
Unauthorised persons are not allowed near the appliance until installation is
completed.
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
Not following the instructions may cause high-energy consumption and poor
performance.
4.2 Preparing the Unit for Operation -
The subsequent steps needs to be followed prior to starting this unit, the set up
time should not take more than 5 minutes.
4.2.1 Installing Rear Spacer -
To ensure proper ventilation, the unit is fitted with a rear spacer that will provide
the appropriate clearance of 75 mm at the back of the unit. The rear spacer is
supplied with the unit and should not be removed.
4.2.2 Levelling the unit -
A spirit level should be used to ensure the unit is levelled in both directions. The
spirit level can be placed on one of the shelves.
A properly levelled unit will avoid possible ice formation on the evaporator’s fins
due to insufficient drainage of the condensate.
To Next Page
Loading...