PRECAUTIONS:
HOW TO CLEAN THE GRINDER?
Remove the receiver, attach the handle to the grinder, and continue to hold
the grinder as demonstrated in the image for the subsequent steps.
1.
Rotate the spin dial counterlockwise to disassemble the grinder.2.
Take out the components in order: spin dial, numerical dial, inner burr,
spring, and bearing cover. ※Note: No need to remove the central shaft.
3.
Use the brush to clean the grinder.4.
Place the components back in order: bearing cover and spring. There are two
shapes of the bearing cover: flat design and curved design. Ensure the curved
design faces upward.
5.
Attach the inner burr and the numerical dial to the rectangle shape of the
central shaft to proceed with the grinder assembly.
6.
Install the spin dial and rotate clockwise to complete the assembly.7.
The entire grinder should not be washed with water. Please use the brush for
cleaning.
1.
Do not rotate the handle when the grind setting is at 0 or below 16 clicks, as
this could damage the burr set.
2.
For precision reasons, do not dismantle the exterior burr. Avoid forcefully
disassembling the grinder with tools.
3.
Only grind coffee beans. Do not grind unroasted coffee beans. 4.
Avoid spraying water directly onto any part of the grinder. You can perform RDT
by spraying water on another object.
5.
Avoid second grinding as the coffee fine powder may block the parts.6.
Please store in a dry environment.7.
To Next Page
Loading...
