MT4500 MODEL NUMBERING SYSTEM ---------------------------------------------------------------------
1
1. MODELS ----------------------------------------------------------------------------------------------
2
2. MOVING ------------------------------------------------------------------------------
---------------------------
2
3. HOW TO INSTALL THE MACHINE ----------------------------------------------
---------------------------
3
3
4
4. BEFORE OPERATION -------------------------------------------------------------------
---------------------------
5
5. NEEDLES ------------------------------------------------------------------------------
---------------------------
5
6.
CAUTION IN SETTING UP MOTOR BELT ---------------------------------------------------------------------
6
7. LUBRICATION --------------------------------------------------------------------------
---------------------------
7
8.
ASSEMBLING THE TENSION STAND OF MT4500/MTS4500---------------------------------------------------------------------
8
9.
ASSEMBLING THE TENSION STAND OF MT4000---------------------------------------------------------------------
9
10. THREADING THE MACHINE ------------------------------------------------------------------
---------------------------
10
11.
THREADING DIAGRAM FOR MT/MTS 4501 ---------------------------------------------------------------------
11
12.
THREADING DIAGRAM FOR MTT/MTS 4504 ---------------------------------------------------------------------
12
13.
THREADING DIAGRAM FOR MTT/MTS 4506 ---------------------------------------------------------------------
13
14.
THREADING DIAGRAM FOR MTT/MTS 4509 ---------------------------------------------------------------------
14
15.
THREADING DIAGRAM FOR MTT/MTS 4512 ---------------------------------------------------------------------
15
16.
THREADING DIAGRAM FOR MT4001 ---------------------------------------------------------------------
16
17.
THREADING DIAGRAM FOR MT4004 ---------------------------------------------------------------------
17
18.
THREADING DIAGRAM FOR MT4006 ---------------------------------------------------------------------
18
19.
THREADING DIAGRAM FOR MT4009 ---------------------------------------------------------------------
19
20.
THREADING DIAGRAM FOR MT4012 ---------------------------------------------------------------------
20
21.
ADJUSTING THE STITTCH FORMATION ---------------------------------------------------------------------
21
21-1 Thread tension adjustment --------------------------------
----------------------------------------------------------------
21
21
21
22.
TIMING OF THE LOOPER TO THE NEEDLE ---------------------------------------------------------------------
22
22
22
23. TIMING OF THE RETAINER LOOPER ---------------------------------------------------
---------------------------
23
23
23
24. ADJUSTING THE NEEDLE GUARD --------------------------------------------------------------
23
25.
ADJUSTING THE FEED DOG & STITCH LENGTH ---------------------------------------------------------------------
24
25-1 Feed dog height & tilt -----------------------------------------------------------------------
--------------------------------
24
25-2 Stitch length ----------------------------------------
-----------------------------------------------------------------------
24
26. ADJUSTING THE PRESSER FOOT -----------------------------------------
--------------------------------------------------------------
25
26-1 Presser foot pressure -----------------------------------------
--------------------------------------------------------------
25
26-2 Position of the presser foot and foot lift --------------------------------------
-----------------------------------------------------------------
25
27.
ADJUSTING THE REAR PULLER DEVICE ---------------------------------------------------------------------
26
27-1 Manual lever and position of the stopper ------------------------
--------------------------------------------------------
26
27-2 To adjust the puller pressure --------------------------------------
-----------------------------------------------------------------
26
28. CLEANING THE MACHINE --------------------------------------
-----------------------------------------------------------------
27
29. MT SERIES TABLE CUT-OUT -------------------------------------------------------------
------------------------------------------
28
29-1 Short Table Top Type ------------------------------------------------------------------------------
28
28
29-3 Long Table Top Type ------------------------------------------------------------------------
29
29
30
30. MT SERIES TABLE CUT-OUT -------------------------------------------------------------
------------------------------------------
31
30-1 Short Table Top Type ------------------------------------------------------------------------------
31
IMPORTANT SAFETY INSTRUCTION ---------------------------------------------------------------------
32
MT4500 SERIES CONTENTS
21-2 Position of the needle thread eyelet -----------------------------------------------
-------------------------------------------------
21-3 Adjusting the needle thread guard -----------------------------------------
-------------------------------------------------------
3-1 How to install MT series ------------------------------------------------------------------
---------------------------
3-2 How to install the tension stand of MT4509~MT4525 --------------------------------
---------------------------
29-2 Semi-Submerged Type ----------------------------------------------------------------------------------
22-1 Positioning the looper and the looper rocker ---------------------------------------------------------------------
22-2 Looper left-to-right movement -----------------------------------------------------------
---------------------------
23-1 Installing the retainer looper ------------------------------------------------------------------
---------------------------
23-2 Timing of the retainer looper to the needle ---------------------------------------------------------------------
29-5 Applicable Models: MT4500 Class With "MP001+TC" Devic
--------------------------------------------
29-4 Applicable Models: MT4500 Class With "PS001" Devic
--------------------------------------------
To Next Page
Need help?
General
