To Next PageTo Next Page
Need help?Do you have a question about the Kingtex NT67 and is the answer not in the manual?
Code for 4-needle 6-thread flat seaming series and model identifier.
Codes for machine application, material weight, and needle distance.
Details on mounting machine heads, motor assemblies, and available optional devices.
Describes assembly methods for motor table top and hanging styles.
Diagram showing dimensions and cutting details for the machine table.
Illustrates the dimensions and mounting points for the TTS11 motor support.
Table detailing pulley diameter, machine speed, and V-belt sizes for selection.
Instructions for installing and adjusting the tension of the V-belt.
Detailed steps for installing the belt cover on TTS11 models.
Instructions for installing the belt cover on HTS21 models.
Steps to install thread guide plate supports and adjust thread pipes.
Procedure for adding lubricating oil to the machine.
How to lubricate external moving parts of the machine.
Verification process to ensure the oil circulation system is working correctly.
Procedure for adding silicone oil for specific thread types or conditions.
Instructions for changing the lubricating oil after a specified period.
Details on needles used with the NT67 series and selection criteria.
Procedure for installing and replacing sewing needles.
Instructions and precautions for threading the sewing machine.
Illustration showing the path of each thread through the machine.
How to adjust thread tension based on fabric and sewing conditions.
Guidelines for setting the presser foot pressure to the lowest stable level.
Setting the presser foot height for optimal sewing results.
Procedure for adjusting the presser foot height and clearance.
How to use the differential feed lever to adjust stitch shrinkage or stretch.
Steps to adjust the stitch length, including considerations for increasing it.
Setting the standard position for the fixed knife blade.
Procedure to adjust the fabric overlap width by moving knives.
Setting the lap former to align with needles and stitch plate.
Adjusting needle thread tension using strike-off pins.
Modifying pin positions to alter needle thread loop size.
Standard settings and adjustments for needle thread eyelets.
Adjusting needle thread tension by moving eyelets.
Function and adjustment of the stitch unlock spring.
Setting the looper thread take-up guide alignment.
Adjusting the timing of the looper thread take-up for proper thread delivery.
Setting the position of looper thread take-up eyelets.
Setting the position of the top cover thread take-up eyelet.
Adjusting the timing for the top cover thread take-up mechanism.
Procedure for setting and adjusting the needle bar height.
Positioning the top cover thread carrier for proper loop formation.
Setting the clearance for the top cover thread hook.
Procedure for installing the looper into the looper holder.
Setting the correct horizontal distance between the looper and needle.
Adjusting the front-to-rear clearance between looper and needle.
Setting the standard clearance for the front needle guard.
Method to check the correct setting of the front needle guard.
Setting the standard clearance for the rear needle guard.
Procedure for installing the differential and main feed dogs.
Adjusting the height of feed dogs relative to the stitch plate.
Step-by-step instructions for disassembling the presser foot assembly.
Instructions for removing the presser foot spring plates.
Procedure for reinstalling the presser foot spring plates.
Adjusting the pressure and clearance between the upper and lower knives.
Procedure for replacing the upper and lower knife blades.
Fine-tuning the cutting angles between the upper and lower knives.
General| Brand | Kingtex |
|---|---|
| Model | NT67 |
| Category | Sewing Machine |
| Language | English |
