10. 設定裁片疊向導模
NT67 標準疊向為左疊縫
10-1 標準設定位置
導模的尖端“A”對正四支針的中間，
如果在必要時放鬆螺絲，可修正尖端“A”
的位置，導模座推向前與針板外緣接觸，
依裁片的厚度可稍稍退開一點。
10. Use of lap former
Align the point A of the lap former with
the center of four needles.
Depending on lapped edges of the fabrics
or fabric feeding. loosen the screws and
adjust the position.
Set the position where the lap former slide
block touches and stops in the front of
the stitch plate.
Depending on fabric thickness, adjust the
position slightly toward the operator.
To Next Page
Loading...
