8. 調整縫目節距
縫目節距範圍 1.6~2.5mm
※ 注意，先調整差動比調整後再調整縫目
節距。
※ 如果是加大縫目節距，必須先把後導針器
鬆開後退
1. 放鬆固定螺絲，退開後導針器。
2. 打開孔塞
3. 放鬆螺樁向上移動加大節距，向下移動
減小節距
4. 完成後鎖緊螺樁及孔塞
5. 重新設定後導針器的位置
8. Adjusting stitch length
Stitch length ranges 1.6 – 2.5mm as standard
and can be adjusted infinitely.
(1) Loosen the screw and move the needle
guard (rear) most backward. Then tighten it
slightly.
※ This procedure is skipped if decreasing
the stitch length.
(2) Remove the plug screw.
(3) Loosen the screw to adjust the stitch length.
To increase stitch length, move the screw
upward.
To decrease stitch length, move the screw
downward.
(4) Tighten the screw securely and reset the
plug screw.
(5) Adjust the position of the needle guard (rear)
and tighten the screw securely.
To Next Page
Loading...
