4-4 添加矽油
使用化纖線或是化纖類裁片，發生熔解或跳線的情形時，
可使用矽油來冷卻
1. 將羊毛氈座放入矽油槽裡
2. 添加矽油於油槽內
3. 蓋回護蓋
4-4 Needle sp container
Needle sp container is equipped as standard
to prevent thread breakage
and skip stitch when running the machine at high
speed or using synthetic thread and/or synthetic
fabric.
Fix the felts, (included inside the accessories
box), into the sp container when using.
Use dimethyl silicone oil.
Open the oil cup lid and check the oil amount.
If not sufficient, supply oil into the sp container.
4-5 更換 / 潤滑油
新機器使用 150 小時或是開始使用後最初 1 個月，請更換潤滑油。
參照附圖 A、B。
圖 A，取下皮帶蓋打開卸油孔塞，殘油滴盡後重新裝回孔塞及皮帶蓋。
圖 B，打開卸油孔塞，殘油滴盡後，重新裝回孔塞。
4-5 Changing oil
When using a new machine, change the ubricating oil after running for
200 hours (for about one month).
To Next Page
Loading...
Need help?
General
