4-2 外裝活動件潤滑
新機器使用前或是長時間沒有使用的縫機，在使用前，請參照圖的部位
添加少許潤滑油。
※ 注意，太多的潤滑油會順流到上切刀及壓腳底，導致裁片受到污染。
4-2 Replenishing oil
Replenish a drop of oil from the points indicated arrows with an oilier
(in accessories box) if needed.
If oil leaks around the presser foot and the upper knife, it can cause oil
stain on the material.
Be sure to wipe it out completely.
4-3 確認潤滑工作正常
新機器或是長期未使用的縫機，啟動運轉時請觀察循環油視窗、，
注意是否有油噴出。
如果在或油窗上沒有看到循環油噴出，請停止縫機，將、螺樁卸下，
在孔內注入些許潤滑油，鎖回螺樁、後再重新啟動縫機。
4-3 Checking lubricating of oil
Pour oil if oil does not circulate completely when installing a new machine
or running a machine which has not been used for a while.
Remove the plug screws of the pump driven gear to pour oil. Run the machine after
resetting them.
To Next Page
Loading...
Need help?
General
