4. 潤滑
4-1 添加潤滑油
必須使用 VG68/ISO 或同等級的潤滑油。
打開注油孔孔塞、，加入潤滑油，注意加入潤滑油的同時，
觀察油面指標及油面計不可超出上限，完成後請再次鎖緊、注油孔塞，
並於使用縫機時，經常檢查油面高度。
4. Lubrication
4-1 Lubricating
Remover the plug screws and where indicated “OIL” and supply oil.
pouring Oil VG68/ISO thru the plug screw, supply oil until the oil level
indicator reaches the upper line in the oil sight gauge.
Pouring oil thru the plug screw, supply oil to the upper line in the oil
sight auge.
Check the oil level between the lines in the oil sight gauges and before
running the machine.
If it is under the lines, supply adequate oil.
Check the oil splashes from the nozzle inside the oil sight top windows
and when starting to run the machine.
To Next Page
Loading...
