KINNEY KT-150 - User Manual

Other manuals for KINNEY KT-150

Questions and Answers

A
Adrienne GonzalezAug 17, 2025
What to do if there is oil in the inlet piping of my KINNEY Water Pump?
- R
  Raymond HartAug 17, 2025
  If you find oil in the inlet piping of your KINNEY Water Pump, this may be due to the piping being at an incorrect level, in which case you should add an inlet elbow. It might also happen if the gas ballast valve was left open when stopping the pump, so add a manual or automatic valve. The absence of an isolation valve and vent valve can also cause this issue, so you should add them.
A
Anthony SmithAug 22, 2025
Why is my KINNEY Water Pump vibrating?
- A
  Aaron GatesAug 22, 2025
  If your KINNEY Water Pump is vibrating, it might be caused by inflexible inlet or outlet connectors. Consider using KINNEY flexible connectors or more flexible alternatives. Another possible reason is incorrect or improperly positioned vibration mounts. Check to ensure that the vibration mounts are installed correctly.
S
Samantha McknightAug 28, 2025
What to do if my KINNEY KT-150 Water Pump stalls?
- M
  Martin ButlerAug 28, 2025
  If your KINNEY Water Pump stalls, it could be due to several reasons. You should check the power at the motor, referring to the manual section on installation, as there may be an electrical loss of power. Slipping belts could also be the problem, so refer to the maintenance paragraphs on V-belt drive and changing the oil. The pump itself might be malfunctioning, so consult the manual section on general operation. Another cause may be contaminated or insufficient pump oil, in which case you should disassemble and clean the pump. The pump could also be too cold, or there could be foreign particles in the pump.
P
Patricia BellSep 4, 2025
How to fix excessive noise at low pressure in KINNEY Water Pump?
- J
  Janet BakerSep 4, 2025
  To address excessive pump noise at low pressure in your KINNEY Water Pump, try opening the gas ballast valve. This can help reduce hydraulic noise from the pump discharge.
J
josephwilsonNov 9, 2025
Why is the ultimate pressure of my KINNEY KT-150 system excessively high?
- G
  Garrett WhiteNov 9, 2025
  If your KINNEY Water Pump system's ultimate pressure is excessively high, it could be due to several reasons. The process equipment might be contaminated, requiring cleaning with acetone, alcohol, or similar solvents. There might be leaks in the process equipment or the pump itself, so conduct a leak check and repair as needed. Restricted oil flow, indicated by the oil level not changing with pump pressure, suggests that you should change the pump oil. Also, the vacuum pump oil might be contaminated, so you should refer to the manual sections about changing the pump oil and oil contamination. A malfunctioning discharge valve also can be the cause, so check the valves according to the manual section on discharge valves. The vacuum pump shaft seal could be malfunctioning, in this case you sh...