2. IDENTIFICATION OF COMPONENTS 3. PRE-OPERATION CHECKS
(1). Fuel tank (9). Starter handle
(2). Engine swith (10). Air cleaner
(3). AC breaker (11). Fuel valve
(4). Fusible cut-out (12). Carburetor valve
(5). DC terminal (13). Fuel tank cap
(6). AC receptacle (14). Framework
(7). Grounding terminal (15). Exhaust muffler
(8). Oil filler cap (16). Spark plug
Be sure to perform the following checks before starting the generating set.
3-1 Check whether the generating set is on a level surface.
3-2 Check the level of engine oil
(1) Take out the oil filler cap and clean the measure mark with a clean rag. (see
fig.8)
(2) Insert the oil filler cap without rotating it.
(3) If the oil level is below the lower level, refill the oil till the upper level.
(4) Tighten the oil filler cap.
3-3 Check fuel level
(1) Open the fuel tank.(see fig.9)
(2) Check fuel level, refuel if the level is too low.
(3) Refuel till the shoulder of the fuel filter.
(4) Tighten the fuel tank cap.
Fig.9
----
To Next Page
Loading...
Need help?
General
