IG6000H
1
2
5 4 3
7 6
1. IG6000H Chassis- installed 5. 10” Wheel
2. Support Bracket- (4) 6. Wheel Washer (4)
3. Front Stabilizer (2) 7. Wheel Clip
4. Axle Assembly
Assembly:
1. Install the four support brackets and secure with bolts.
2. Attach the front stabilizers to the chassis (below the handles)
3. Attach the axle assembly.
4. Install one washer on the axle against each welded stop.
5. Install the two wheels.
6. Install the two remaining washers and secure with the wheel clips.
The handles are preassembled before packaging. To raise the handles, simply raise the handle
assembly to a horizontal position. To retract the handles, slide the chrome collars toward you to clear
the sleeve and lower them to the starting position.
-31-
To Next Page
Loading...
