3.1. Change network configuration
The administrator may want to allow DHCPv4 auto-configuration or change the default
IPv4 address by other one. This can be done by accessing the “Network” menu in the Web
Admin.
In the picture above, the new IPv4 address acquired by DHCP is 10.1.1.163. It is now
possible to connect to KTBRN1 through SSH client to this IPv4 address or also to IPv6
link-local address if the PC is connected to the same network. Besides KiBRA will use
this exterior IPv4 address for its NAT64 function.
Note: A reboot may be required to make sure that new settings are correctly applied.
To Next Page
Loading...