2. Installation Guide
2.1. Download required software
Make sure you get the latest release of our Debian-based image for KTBRN1 that includes
KiBRA software, which you will can find on our website, in the following URL.
KTBRN1 + KiBRA image file
Likewise, download the file KiBRA-v2.x.x.zip for later use.
The following software is needed in order to update the image stored in your SD card or
to flash a new one.
Balena Etcher
A Serial terminal or/and SSH client will be required for connecting to KTBRN1 device.
MobaXterm free (Any other software can be used)
Zadig (in case of needing to install USB Serial drivers)
2.2. Flash image to SD card
In case it is needed to update or flash an image to SD card, please follow the instructions
bellow:
1) Install and launch Balena Etcher.
2) Select the file with extension
.gz
in Etcher.
3) Put the micro SD card in a card reader in the computer and select it in Etcher. It is
recommended to use micro SD card class 10 A1-rated and at least 2 GB of
capacity.
To Next Page
Loading...