PT8000 Service Manual
1
Chapter 1 Overview
1.1 Introduction
This manual applies to the service and maintenance of PT8000
series of mobile radios, and is intended for use by engineers and
professional technicians that have been trained by Kirisun. It
contains all required service information for the equipment.
Kirisun reserves the right to modify the product structure and
specifications without notice in order to enhance product
performance and quality. You can also log on our website
www.kirisun.com
to download the latest service manual or contact
your local dealer or us.
Please read this manual carefully before repairing the product.
1.2 Service Attentions
* Safety
Do not contact the antenna connector or PCB with your skin
directly.
Do not reverse the battery polarity.
It may cause harm to the radio if signal input on the antenna
connector is larger than 20dBm (100mW).
Do not turn on the radio before the antenna or load connection
is completed.
Do not touch the antenna while the mobile radio is
transmitting, otherwise, it may cause light burning on skin.
* Explosive Atmosphere
It’s prohibited to use or repair the radio in the following
places:
Hospital, health center, airport
Any area with a potentially explosive atmosphere (e.g. orlop
deck of the ship, storage or transportation equipment for fuel and
chemical etc.)
Any place near blasting sites or area with electrical blasting
cap.
* Replacement Parts
All components used for repair should be supplied by Kirisun.
Components of the same type available on the market are not
surely able to be used in this product and we do not guarantee the
quality of the product using such components.
If you want to apply for any component from Kirisun, please
fill in an application form as below.
Component Application Form
Radio
Model
Component
Position
Mark
Model/
Specifications
Part No. Qty
PT8000-02 FET Q3 RD01MUS1 105-RD01MU-R01 1
PT8000-02 Triode Q49 2SC5108(Y) 104-SC5108-001 1
1.3 Service
All the Kirisun products are subject to the service warranty.
After-sales service will be provided, and the length of
warranty is stated by Kirisun. The radio and its accessories are all
in the warranty. However, in one of the following cases, charge
free service will be not available.
* No valid warranty card or original invoice.
* Malfunction caused by disassembling, repairing or
reconstructing the radio by the users without permission.
* Wear and tear or any man-made damage such as mechanical
damage, burning or water leaking.
* Product’s serial number has been damaged or the product
trademark is difficult to identify.
After the warranty expires, lifetime service is still available.
We also provide service components to service stations and staffs.
Chapter 2 Unpacking, Checking and
Installation
2.1 Unpacking and Checking
Please carefully check the radio in the package and the
supplied accessories listed in the following table before using. If
any article is found lost or damaged, please contact the distributor
without delay.
No. Accessories Qty
1 Mounting Bracket 1
2 Power Cable 1
3 Hand Microphone 1
4 Microphone Hanger 1
5 M4*10 SEMS Screw 4
6 M4*16 Self-tapping Screw 2
7 M5*16 Self-tapping Screw 4
8 Instruction Manual 1
Mounting Bracket
DC Power Cable
Hand Microphone
Microphone Hanger
M4*10 SEMS Screw
M4*16 / M5*16
Self-tapping Screw