cannot communicate with each other.
Value Range: The CTCSS ranges from 0~254.1Hz, the stepping is 0.1 Hz, default value is 67 Hz.
CDCSS: If select CDCSS or –CDCSS, needs to select a CDCSS value, or the transmitter and
receiver cannot communicate with each other.
Value Range: 0~777(octal number), the stepping is 1, the default value is 023.
Notes:
1. Squelch level only use for analog channel.
2. Mix channel cannot select CSQ, must select CTCSS, CDCSS or –CDCSS.
4 Program Menu
Read Data：Read data from the repeater
When reading data, a bar pops up and shows the reading process. When finish reading, software
will pop up a dialog box, shows ―Read data successfully‖.
When you try to read data, tick the option ―Exit after finish‖, when finish reading data, the dialog
box will exit automatically. If not tick this option, users have to press ―Exit‖ manually to close the
box.
Write Data: Write the configurations into the repeaters.
When writing data, a bar pops up and shows the writing process. When finish writing, software will
To Next Page
Loading...
Need help?
General
