c) Apply Grease/Oil to all link, pins and rivets.
d) Check for tightness of all fasteners.
g) Wash and clean the machine periodically.
i) Keep Machine in level platform.
J) During storage, and whenever the power unit is unattended, disengage the PTO
(power take- off) and render the engine unstartable by disconnecting the battery.
h) When storing the machine for longer intervals, use the spring latch to latch the
clutch lever in the depressed (disengaged) position. This prevents the clutch cone
from sticking to the lining during storage.
i) Store the machine in a well-ventilated place, protected from dampness and the
weather.
3.3 Don’ts
1. Do not put hands or feet near or under rotating parts.
2. Don’t operate the MINT 8 DLX without any Demonstration training.
3. Do not operate if you found any leakage of Fuel or lubricants.
4. Never place your hands, feet, or any part of your body near or under any moving part
while the MINT engine is running.
5. Do not touch the muffler and engine when the machine is in use.
6. Do not use this machine around large roots and surface rocks.
7. Do not use this machine around underground pipes and wiring.
8. Do not use machine when fuel leakage is observed near FIP, Injector and Fuel lines.
9. Do not operate the machine without good visibility.
10. Do not tamper with any safety devices or fittings.
11. Do not use unapproved attachments.
12. Don’t use non recommended blades.
13. Disengage clutch before shifting gear
14. Ensure gears are aligned properly during shifting and if not release clutch to align the
gear.
15. Do not wear open-toed sandals or go barefoot when operating the machines.
16. Do not wear loose fitting, scarf, ties or jewels which might caught in the machine
while operating.
17. Do not operate the MINT 8 DLX on terrain.
.,5/26.$52,/(1*,1(6/,0,7('
$.LUORVNDU*URXS&RPSDQ\
To Next Page
Loading...
