4. Occasionally as needed
Clean any dirt and old grease from the PTO
connections of all equipment and pack with clean
bearing grease.
5. Seasonally
Lubricate the control cables with a light oil;
Clean parts thoroughly and apply grease to the
control column indexing rod or lever, column fork,
column support or pivot post.
6.8 Use and Care Of Attachments
Lubrication of Attachments
1.Rototiller and cover assembly: Remove the pipe plug on top of the attachment gear
housing. If the oil level is more than 2 inches (50 mm) below the filler hole, fill to the top
with SAE 80/ 90 or SAE 90EP (extreme pressure) gear oil. Maintain at the nearly full level.
2. All other attachments: Remove dirty grease and lubricate the PTO coupling of the
Attachment with bearing grease whenever greasing the unit PTO.
6.9 Coupling Attachment To PTO
When the PTO flange of the attachment is coupled to the unit PTO flange and the PTO is
engaged, the splined shaft slides out to engage the splined (grooved) shaft of the
attachment. Then the shafts rotate as a single member until the PTO shift lever is used to
retract the drive shaft.
Although the attachment may be coupled directly to the unit PTO, there is a quick hitch that
can shorten the time for coupling and uncoupling attachments. There are also PTO
extensions in lengths of 3" and 6"which can be coupled between the PTO and attachment
for better balance with certain attachment and engine combinations.
.,5/26.$52,/(1*,1(6/,0,7('
$.LUORVNDU*URXS&RPSDQ\
To Next Page
Loading...
