KitchenAid 5KSMVSA - Assembling the Fresh Prep Slicer;Shredder Attachment

ENGLISH
USING THE STAND MIXER ATTACHMENT | 11
USING THE STAND MIXER ATTACHMENT
2
Slide the blade you want to use into
the housing� You will hear a click
when the blade snaps into place
properly on the drive shaft�
ASSEMBLING THE FRESH PREP SLICER/SHREDDER ATTACHMENT
1
Turn the Stand Mixer off and unplug�
4
Insert the attachment shaft housing
into the attachment hub, making
certain the power shaft fits into the
square hub socket� If necessary, rotate
the attachment back and forth� The
pin on the attachment housing fits
into the notch of the hub rim when
in the proper position�
5
Tighten the Stand Mixer attachment
hub knob until the attachment
is completely secured to the
Stand Mixer� Make sure that the
hub knob is properly seated in the
retention hole in the attachment�
3
For Stand Mixers with a hinged attachment hub cover: Flip up to open�
For Stand Mixers with a removable attachment hub cover: Turn the attachment
knob counterclockwise to remove attachment hub cover�
W10916600A_01_EN_v15.indd 11 1/25/17 3:37 PM