7. Use the burr cleaning brush to clean the rotating burr and the stationary burr which is mounted on the bottom of
the grind ring. (Note: Never wash the burrs in water. Keep them dry at all times.)
8. After cleaning the rotating burr, place it back onto the motor shaft. Be sure to line up the drive slot on the bottom of
the burr with the drive pin on the motor shaft.
9. Rotate the rotating burr slowly to be sure that the drive slot on the burr is in place on the drive pin on the motor
shaft. When correctly positioned, the motor shaft will turn when the rotating burr is turned.
https://producthelp.kitchenaid.com/Countertop_Appliances/Coffee_Products/Product_Info/Coffee_Product_Assembly_and_O…
Updated: Thu, 12 Aug 2021 20:09:57 GMT
Powered by
4
To Next Page
Loading...
