The oven light is a standard 40-watt appliance bulb. Before
replacing, make sure the oven and cooktop are cool and the
control knobs are in the off position.
To Replace:
1. Unplug range or disconnect power.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.
TROUBLESHOOTING
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
to possibly avoid the cost of a service call.
www.kitchenaid.com
Cooktop will not operate
Plug into a grounded outlet.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
See "Sabbath Mode" section.
Push in knob before turning to a setting.
Operation
PROBLEM POSSIBLE CAUSES SOLUTIONS
Nothing will operate Power supply cord is unplugged.
Household fuse is blown or a
circuit breaker is tripped.
Range is in Sabbath Mode.
The control knob is set
incorrectly.
The range is in Demo Mode. Demo Mode will deactivate the Warm Zone element. See
"Demo Mode" in the "Electronic Oven Controls" section.
Excessive heat around Cookware that is not the proper Use cookware about the same size as the surface cooking
cookware on cooktop size area, element or surface burner. Cookware should not extend
more than 1/2"(1.3 cm) outside the cooking area.
Cooktop cooking results not Control knob set to incorrect heat See "Cooktop Use" section.
what expected level
Oven will not operate
Range is not level.
The electronic oven control was
set incorrectly.
Delay Start was set.
The oven control lockout is set.
Level the range. See the Installation Instructions.
See "Electronic Oven Controls" section.
See "Cook Time" section.
See the control lock keypad feature in the "Feature Guide"
section.
The range is in Demo Mode. Demo Mode will deactivate all heating elements. See "Demo
Mode" in the "Electronic Oven Controls" section.
"FEATURE NOT AVAILABLE" is A cooktop or oven function is Ensure that all cooktop and oven functions are off, and that the
displayed when trying to use active, including the timer or cooktop and oven are cool. If this does not work, call for
the Control Lock function, timed cooking features, or the service. See cover for contact information
oven is hot or a cooktop hot
surface indicator is lit.
Convection fan not working Oven door is open. Close oven door. See "Convection Cooking" section.
Oven temperature too high or Oven temperature calibration See "Oven Temperature Offset Control" in the "Electronic Oven
too low needs adjustment Controls" section.
Temperature has been changed See "Fahrenheit and Celsius" in the "Electronic Oven Controls"
to Fahrenheit or Celsius. section.
Oven indicator lights flash Needs service (oven indicator See "Control Display" in the "Electronic Oven Controls"
lights are flashing) section. If the indicator light(s) keeps flashing, call for service.
See cover for contact information.
Display shows messages Power failure (display shows Clear the display. On some models, reset the clock, if needed.
flashing time) See "Clock" keypad feature in the "Feature Guide" section.
Error code (display shows letter
followed by number)
Press the OFF keypad to clear the display. See "Control
Display" in the "Electronic Oven Controls" section. If it
reappears, call for service. See cover for contact information.
17
To Next Page