CMD + SHIFT CLICK TO CHANGE COPY CMD + SHIFT CLICK TO CHANGE COPY
10
ASSEMBLING THE FOOD PROCESSOR
Before rst use
Attaching the work bowl
1
Place the work bowl on the base,
aligning the raised portion with the
indentation on the base. The center
hole should fit over the power shaft.
Power Shaft
2
Grasp the work bowl handle and turn
the bowl counterclockwise to lock it
on the base.
IMPORTANT: Your Food Processor will not operate unless the work bowl and work
bowl cover are properly locked on the base, and the large pusher is inserted to the
maximum fill line on the feed tube (approximately halfway down).
ASSEMBLING THE FOOD PROCESSOR
NOTE: Your Food Processor is shipped with the work bowl cover installed on the work
bowl, with the mini-bowl inside the work bowl.
1
Grasp the feed tube on the work bowl
cover and turn it clockwise to remove it
from the work bowl.
2
Lift out the mini-bowl.
Before using your Food Processor for the first time, wash all parts and accessories
either by hand or in the dishwasher (see “Cleaning the Food Processor” section).
IMPORTANT: Place the Food Processor on a dry, level countertop with the controls
facing forward. Do not plug in the Food Processor until it is completely assembled.
W10745720A_EN_v09.indd 10 10/8/14 6:10 PM
To Next Page
Loading...
