10
arb
TO ATTACH POURING SHIELD
1. Be sure speed control is OFF and
mixer is unplugged.
2. Place bowl lift handle in down
position.
3. Attach flat beater, dough hook or
wire whip and bowl.
4. Place bowl lift handle in up position.
5. Slide pouring shield collar around
beater shaft, centering collar over rim
of bowl. Then, rotate opening in
collar toward front of mixer.
6. Fit tabs on the side of pouring chute
into notches on the collar.
7. Fit the three notched guides on
bottom of chute along rim of bowl.
TO USE POURING SHIELD
1. Pour ingredients into bowl through
chute portion of shield.
2. Important: make sure the guides on
the bottom of the chute rest on the
rim of the bowl to keep ingredients
from falling outside the bowl as they
are added.
TO REMOVE POURING SHIELD
1. Be sure speed control is OFF and
mixer is unplugged.
2. Remove pouring chute from collar.
3. Slide pouring shield collar off bowl.
4. Place bowl lift handle in down
position and remove attachment and
bowl.
HOUSEHOLD MIXER
SPEED CONTROL
Plug mixer in proper electrical outlet.
**
Speed control lever should always be set
on lowest speed for starting, then
gradually moved to desired higher speed
to avoid splashing ingredients out of bowl.
See page 13 for Speed Control Guide.
OVERLOAD RESET
If the mixer stops due to overload, slide
the speed control lever to OFF.
This automatically resets the mixer. Wait
a few minutes. Slide the Speed Control
Lever to the desired speed and continue
mixing. If unit does not restart see
page 5 “How to Arrange for Service.”
To Next Page
Loading...
Need help?
General
