arb
9
Assembling Your 6 Quart Mixer
TO ATTACH BOWL
1. Be sure speed control is OFF and
mixer is unplugged.
2. Place bowl lift handle in down
position.
3. Fit bowl supports over locating pins.
4. Press down on back of bowl until
bowl pin snaps into spring latch.
5. Raise bowl before mixing.
6. Plug mixer in proper electrical outlet.
**
TO RAISE BOWL
1. Rotate handle to straight-up position.
2. Bowl must always be in raised,
locked position when mixing.
TO LOWER BOWL
1. Rotate handle back and down.
TO REMOVE BOWL
1. Be sure speed control is OFF and
mixer is unplugged.
2. Place bowl lift handle in down
position
3. Remove flat beater, wire whip, or
dough hook.
4. Grasp bowl handle and lift straight
up and off locating pins.
TO ATTACH FLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
1. Slide speed control to OFF and
unplug.
2. Slip flat beater on beater shaft.
3. Turn beater to left, hooking beater
over the pin on shaft.
4. Plug mixer in proper electrical outlet.
**
TO REMOVE FLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
1. Slide speed control to OFF and
unplug.
2. Press beater upward and turn right.
3. Pull beater from beater shaft.
RAISE
** See page 6.
PIN
To Next Page
Loading...
Need help?
General
