8
PRODUCT USAGE
Plug Stand Mixer into proper electrical
outlet. Always set speed control lever
on lowest speed to start, then gradually
increase speed to avoid splashing
ingredients. See “Speed Control Guide”
chart.
1
(OPTIONAL) To adjust Beater to Bowl
Clearance: Tilt and lock* the Motor
Head back. Turn the screw slightly
counterclockwise (left) to raise the beater,
or clockwise (right) to lower it.
NOTE: If you over-adjust the screw, the
4.8 L Bowl lock lever may not lock into
place.
(OPTIONAL) Place the Pouring Shield**:
Slide the Pouring Shield** from front of
the Stand Mixer over the 4.8 L Bowl. The
bottom rim of the Pouring Shield** fits
inside of the 4.8 L Bowl.
PRODUCT ASSEMBLY
**Included with select models only.
*Locking option is available on selected models.
OPERATING THE SPEED CONTROL
NOTE: The Stand Mixer may warm up during use. Under heavy loads with extended
mixing time, the top of the unit may become hot. This is normal.
Electrical Shock Hazard
Plug into an earthed outlet.
Do not remove earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in
death, fire, or electrical shock.
To Next Page
Loading...
