USING THE PRECISE HEAT MIXING BOWL
4
Remove the stainless steel bowl liner
from inside the Precise Heat Mixing
Bowl base, by turning to unlock, then
lifting the liner out of the base.
3
For Bowl-Lift Stand Mixers: place the bowl-lift lever on the Stand Mixer in the down
position. Pull up on the Precise Heat Mixing Bowl to disenage the snap-lock, and lift to
remove the Precise Heat Mixing Bowl from the bowl-lift arms.
For Tilt-Head Stand Mixers: Tilt the Stand Mixer motor head back. Turn the Precise Heat
Mixing Bowl gently in a counterclockwise direction on the clamping plate to remove.
Removing the Precise Heat Mixing Bowl from the Stand Mixer
2
If necessary, remove any accessories
from the Stand Mixer (see the
“Instructions” manual that came with
your Stand Mixer for more information).
1
Be sure the Stand Mixer’s speed control
is OFF and Stand Mixer and Precise Heat
Mixing Bowl are both unplugged.
IMPORTANT: Attachments may by hot.
Allow them to cool before removing.
W10719715A_EN-Final.indd 14 11/18/14 1:21 PM
To Next Page
Loading...
