Crib Mode
5. Slide the bassinette crib liner
support bar into the crib liner pocket
and attach the liner to the inside of
the crib with the zip. Fig 5. and insert
the mattress Fig 5a.
6. Ensure the drop side rail is
attached to the top of crib Fig 5a
and that the zips have been fully
done up and are connected to the
clips in the pockets. Fig 6.
7. To select a different height, slide the
top button upwards and then press
inwards and select desired height.
Fig 7. Repeat for the other side.
The crib can be used in ve
different heights and the head end
can be a maximum of two heights
higher than the foot end.
NOTE. Never use the crib with the foot
end higher than the head end.
8. To use the storage function, undo
the press studs and undo the outer
zips located on the bottom of the
crib section. Fig 8a. Drop the height of
the crib to its lowest height and press
the foot board clips on to the cross
bar to secure in place. Figs 8b + 8c.
CAUTION
Always apply the brakes when the
product has been positioned in its
place of intended use.
Press down to lock wheels in place.
Fig 5
Fig 5a Fig 6
Fig 7
Fig 8
1. Lift
2. Press
Liner
Zip
A
B
C
Press stud
Zip
Cross
bar
Foot
board
clips
Pocket on underside
Mattress
To Next Page
Loading...
