Playpen Mode
9. Undo the press studs and undo
the outer zips located on the
bottom of the crib section. Fig 9a.
Drop the height of the crib to its
lowest height and press the foot
board clips on to the cross bar to
secure in place. Figs 9b + 9c. Insert
mattress. Fig 9d.
NOTE. Always use the playpen at
its lowest height possible and never
remove the drop side rail.
CAUTION
Always apply the brakes when the
product has been positioned in its
place of intended use.
Press down to lock wheels in place.
Lift up to release brakes.
Fig 9
A
B
C
D
Press stud
Drop the height of the crib
Fully dropped and
base lowered
Lowest
position
Zip
Cross
bar
Mattress
Foot
board
clip
Foot
board
clip
On
Off
To Next Page
Loading...