Klarstein 10028189 - Filter Screen Cleaning; Postseason Storage

Clean the upper lter screen frame
1 Clasp the wedging block of the EVA lter screen frame with
hands. Force down from the outside to remove the EVA
lter screen frame. Unscrew four screws xing the EVA
lter screen and the rear housing to remove the EVA lter
screen (as shown in the above gure) .
2 Put the EVA lter screen into warm water with neutral
detergent (about 40 ℃ / 104 ℉) and dry it in the shade
after rinsing clean.
Clean the lower lter screen frame
1 Hold the handle of the CON lter screen frame, and pull it
outward gently to remove it.
2 Put the CON lter screen into warm water with neutral
detergent (about 40 ℃ / 104 ℉) and dry it in the shade
after rinsing clean.
Postseason Storage:
Unscrew the drainage cover, unplug the water plug, and discharge the water in the water pan into
other water containers or directly tilt the body to discharge the water into other containers.
Turn on the machine, adjust it to low-wind ventilation mode, and maintain this state until the
drainage pipe becomes dry, so as to keep the inside of the body in a dry state and prevent it from
mildewing.
Turn off the machine, unplug the power plug, and wrap the power cord around the wrapping post;
install the water plug and the drainage cover.
Remove the exhaust pipe and keep it properly.
Cover the air conditioning with a plastic bag. Put the air conditioning in a dry place, keep it out of
the reach of children, and take dust control measures.
Remove batteries of the remote control and keep them properly.
Note: ensure that the body is placed in a dry place and keep all machine components properly.
18 19
1
2
3
Clean the lter screen
If the lter screen is clogged with dust, and the effectiveness of the air conditioning is reduced, be
sure to clean the lter screen once every two weeks.
1 Retaining screw
2 Wedging block
3 Wedging block