Klarstein 10032679 - Quick Start Guide; Setting Up Water Drainage; Setting Up Water Supply

30
EN
QUICK START GUIDE
(1) Setting up water drainage
Insert the end of the drain hose into a sink or bucket. Fix the drain hose with suction
cups.
(2) Setting up the water supply
You can ll the device with water in two
ways:
• Permanent connection via the tap (1)
• Manual lling via the cap at the top of
the device (2)
How to tell if there is enough water in
the tank:
Before starting: if the tank is lled with
enough water, the device will beep
several times.
After starting: if there is not enough
water in the tank, the following symbol
will appear:
As soon as there is enough water left in
the tank, the symbol will go out and the
device will beep several times.