EasyManua.ls Logo

Klarstein 10032679 - Foam and Rust Stain Issues; Noise Issues

Klarstein 10032679
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
45
EN
Problem Possible cause Solution
Foam in the tub. Unsuitable dishwashing
detergent.
Only use dishwashing
liquid that is suitable for
dishwashers. If there is any
foam in the tub, open the
door and allow the foam
to evaporate. Put some
cold water in the tub and
close the door. Run any
wash program to remove
the residue.
Overowed rinse aid. Immediately clean up
overowed rinse aid.
Rust stains on the cutlery. The cutlery is not stainless. Only wash stainless
cutlery.
No program was started
after rinsing salt was
relled
After lling, start the quick
program with an empty
dishwasher.
The lid to the rinsing salt
holder is loose.
Make sure the lid is rmly
closed.
Knocking noises in the
interior.
The spray arm is striking
against an object in the
basket.
Interrupt the program and
rearrange the dishes so
that the spray arm is not
obstructed.
Rattling noises in the
interior.
The dishes are not secure. Interrupt the program
and place the dishes in a
secure position.
Banging noise in the water
pipe.
Can be caused by
crossing the water pipes.
Does not affect the
performance of the
dishwasher. If you are not
sure, contact a specialist.

Table of Contents

Related product manuals