Klarstein 10033036 - Operational Errors & Codes

32
EN
Problem Possible causes What to do
Fan noise com-
ing from
the induction
hob.
A cooling fan built into your
induction hob has come on to
prevent the electronics from
overheating. It may continue to
run even after you‟ve turned the
induction hob off.
This is normal and needs no
action. Do not switch the power
to the induction hob off at the
wall while the fan is running.
Pans do not
become hot.
1. The induction hob cannot
detect the pan because it
is not suitable for induction
cooking.
2. The induction hob cannot de-
tect the pan because it is too
small for the cooking zone or
not properly centred on it.
Use cookware suitable for
induction cooking. Centre the
pan and make sure that its base
matches the size of the cooking
zone.
The induction
hob or a
cooking zone
has turned
itself off
unexpectedly,
a tone
sounds and an
error
code is dis-
played.
Technical fault. Please note down the error
letters and numbers, switch
the power to the induction hob
off at the wall, and contact a
qualied technician.
Error codes
Code Reason Solution
E0 Use of wrong, too small a pot Use a correct pot
E2 NTC Open/Short Circuit Please return the device for
repair
E3, E4 Voltage too low, too high Connect the device to a correct
power outlet
E5 Ceramic Plate is over heated Allow the device to cool down,
turn it off completely and then
on again
E6 Overheat Protection Allow the device to cool down,
turn it off completely and then
on again