Klarstein 10033689 - Page 33

33
EN
Beer connector
CO
2
connector
Figure 6 Figure 7
3. Release the lock, open the lid of the dispenser and place the well-assembled keg
into the cooling cavity. Connect the CO
2
connector tube and beer outlet tube with
the keg lifter tube connector.
Note: Make sure all connection of tap mechanism is well connected, and without
damage. And make sure tap valve is on close status, and the CO
2
pressure regulator
knob is at “Off” status.
Close
Open
Figure 8 Figure 9
4. Make sure that the pressure regulator on the lid is in the “-” position. Rotate the
cartridge holder outwardly from the upper cover assembly by an appropriate

unscrew the cylinder sleeve and install a CO
2
cartridge (with 3 CO
2
cartridge


“click” sound, indicating that the cartridge seal has been pierced and the CO
2
gas

upwards and snapped into the upper lid assembly. If the cartridge is replaced,
follow the reverse procedure (make sure the gas is used up when changing the gas
bottle).