45
EN
Problem Possible cause Possible solution
Display shows “FL”. The internal water tank
is full.
Drain out water from the
drain port at the bottom
rear of the appliance.
Others No refrigerant or there is
very little refrigerant.
Contact customer service
(regarding leak detection,
handling, vacuum
pump and refrigerant
replenishment as indicated
on the nameplate).
Anti-freezing protection Wait until the appliance
has defrosted. Operation
will resume automatically.
No intervention is
required.
High pressure protection After the gas pressure
inside the appliance has
returned to normal, the
appliance continues to
operate. No intervention is
required.
Note: If problems occur that are not listed in the table or recommended solutions do
not work, contact customer service..
To Next Page
Loading...
