28
EN
Stainless steel
The stainless steel must be cleaned regularly (weekly) to ensure a long service life. For
this, a special stainless steel cleaning uid may be used.
Control panel
The control panel may be cleaned with warm soapy water. Make sure the cloth is clean
and well wrung out before cleaning the control panel. Use a dry, soft cloth to remove
excess moisture after cleaning.
Important: Use neutral detergents and avoid the use of harsh cleaning chemicals,
strong household cleaners, or products containing scouring agents as these may
affect the appearance of the device and possibly remove the printed symbols on the
control panel.
Grease lter
The fabric lters may be cleaned by hand. Soak them in water
together with a degreasing detergent for about 3 minutes,
then gently brush them with a soft brush. Do not apply too
much pressure to avoid damaging the lter. Then allow the
lter to air dry, but do not place it directly in the sun. Filters
should always be washed separately from dishes and kitchen
utensils.
Remove the lter as shown in the picture at right and
then insert it again in reverse order.
To Next Page
Loading...
