What to do if Klarstein BRILLIANT HEKTOR light is on but the motor doesn't work?
If the light is on but the motor isn't working, it could be due to several reasons: * The fan switch might be turned off. In this case, select a fan switch position. * The fan switch might have failed. In this case, contact customer service. * The motor might have failed. In this case, replace the motor.
Why is my Klarstein BRILLIANT HEKTOR not working? (Light and motor)
If neither the light nor the motor is working, check the following: * Blown house fuses could be the cause. Reset or replace the fuses. * A loose or disconnected power cord. Ensure the cord is properly fitted to the power outlet.
Why is my Klarstein BRILLIANT HEKTOR suction insufficient?
Insufficient suction can occur if the distance between the range hood and the gas top is too far. Refit the range hood to the correct distance.
What to do if my Klarstein Ventilation Hood is leaking oil?
Oil leakage may be due to: * The one-way valve and the outlet are not tightly sealed. Remove the one-way valve and seal with sealant. * Leakage from the connection of the chimney and cover. Take the chimney down and seal it.
How to fix a Klarstein Ventilation Hood that inclines?
If the range hood inclines, it's likely that the fixing screws are not tight enough. Tighten the hanging screws and align the range hood horizontally.
What to do if Klarstein BRILLIANT HEKTOR light is not working?
If the light is not working, the lamp may be damaged. Have the lamp replaced.
Crucial safety information regarding exhaust gases and ventilation in extraction mode.
Details on the correct height above the cooking surface and cutting the cabinet for installation.
Guide to adjusting fan speed and setting the automatic timer function.
Crucial safety information regarding exhaust gases and ventilation in extraction mode.
Details on the correct height above the cooking surface and cutting the cabinet for installation.
Guide to adjusting fan speed and setting the automatic timer function.
General| Brand | Klarstein |
|---|---|
| Model | BRILLIANT HEKTOR |
| Category | Ventilation Hood |
| Number of Motors | 1 |
| Number of Fan Speeds | 3 |
| Lighting | LED |
| Number of Lights | 2 |
| Control Type | Touch |
| Filter Type | Grease Filter |
| Grease filter material | Aluminum |
| Ducting Diameter | 150 mm |
| Width | 90 cm |
| Height | 30 cm |
| Material | Stainless Steel |
| Power Consumption | 213 W |
| Voltage | 220-240 V |
| Frequency | 50/60 Hz |
| Operating Modes | Extraction and recirculation |
To Next Page