36
EN
Cleaning intervals
Accessories Cleaning/replacement
recommended frequency
Clean water tank Clean after each use
Dirty water tank Clean after each use
HEPA lter Clean after each use, replace every
3 - 6 months
Floater Clean after each use
Brush cover Clean after each use
Infrared sensor Clean after each use
Roller brush Clean after each use, replace every
3 - 6 months
Note: The time periods recommended above for replacing the accessories are
only recommendations. The actual cleaning/replacement frequency should
depend on the actual frequency of use.
TROUBLESHOOTING
Problem Possible cause Solution
The unit cannot be charged. The power supply unit is not
connected correctly.
Check the connection of the
power supply unit.
The unit is not properly
connected to the charging
station.
Put the cleaner back on the
charging station.
The handle control does not
work.
The dirty water tank is full. Empty the dirty water tank.
The dirty water tank is not
installed.
Check and install the dirty
water tank.
The roller brush is not installed. Check and install the roller
brush.
To Next Page
Loading...
